Room Additions in Beverly Hills, in the Right Order
Beverly Hills room additions run in a set order: path chosen, design review and permit, house protected, then tie-in, framing, trades and final.
The first physical step on a Beverly Hills addition is protecting the house that stays: dust walls go up inside, the tie-in wall is braced, and floors along the work path are covered. Before that, the design is settled, an addition or an attached ADU chosen, any design review cleared and the permit issued. After protection come demolition at the tie-in, footings, a floor frame set level with the existing floor, walls, roof and the trades, in that order.
Choosing the path first
Beverly Hills reviews a room addition under its single-family zoning standards and may route exterior changes through design review. An attached ADU is judged under the state ADU statute, with its own entrance, kitchen and bath and a fire-rated wall between it and the house. Because the two paths differ in review and rules, choosing between them is the step that has to happen before any drawings. We compare the two for your lot, then draw the one that fits.
Closing up and the final
Once the walls and roof are framed, the new roof is joined to the old one and made watertight before the old exterior wall comes out. Rough plumbing, wiring and ductwork follow, each inspected by the city. Insulation and the energy details are inspected next, then drywall, trim and paint. Finishes are matched to the existing rooms. The work ends with the final inspection, and the protection inside the house comes down only after the dust is cleaned up and the rooms are ready to use.
Room Additions in Beverly Hills: common questions
An addition suits space you will use yourselves, like a bigger kitchen, a primary suite or a family room. An attached ADU suits a separate home with its own entrance and kitchen, for a relative, a caregiver or a tenant. Beverly Hills applies different rules to each, and we test both against your lot before choosing.
Beverly Hills grants one permit that covers the addition and its electrical, plumbing and mechanical trades. Planning checks setbacks, height and floor area, and exterior changes may need design review approval first. We prepare the drawings and calculations, coordinate the review steps and file the set for plan check.
If the structure can carry it and the zoning allows the height and floor area, yes. An engineer reviews the footings and walls, and new footings or shear walls are added where needed. An upper floor in Beverly Hills may also go through design review for how it looks from the street, and we plan for that step.
Room Additions in other cities
More we build in Beverly Hills
Start your room additions in Beverly Hills
Tell us about the property and the project. We reply with what it involves and how we would price it.